Chrysler 300 forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
so back story. mice got into my 300 a couple years ago and ate some injector wiring fixed it but looks like hell plus i had a o2 sensor plug go bad so perfect time to swap. Got a 06 srt harness and i am swapping. all went well and just reinstalling the starter. but.... two power wires to the starter? i didnt pay attention when i was pulling it. sorry for the crappy pic. red wire with the cover is for sure to the starter and the other wire with the bare terminal....starter as well? the bare terminal wire is red farther up and goes into the same harness as the other wire so............
can anybody help? looked online and i am only seeing one wire. where did i go wrong if so?
View attachment 21911

never mind i got it.
 
1 - 1 of 1 Posts
Top