Chrysler 300 forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am needing to replace my 3.5 engine that threw a rod or piston as there is a hole in the side of the block. My 300 is a 2009. I am looking at used due to cost. The question is will a 3.5 engine from a 2010 Challenger work? I've looked at interchange lists and it shows the 2009 Challenger would but not certain about the 2010. The engine in looking at looks the same and the Challenger didn't switch over to the 3.6 liter until 2011.
 
1 - 1 of 1 Posts
Top