[pjscott]

Hi, Does anyone know what issue the following error codes relate too:

Banker Sender2 P0158
Knock Sender p0325

I found these codes after the engine management light came on.

 

[stocksux]

Try this link:
http://www.300cforumz.com/showthread.php?t=2982&highlight=error+code

Welcome to the Z family from Wisconsin.

 

[stillbad]

Welcome to the site ! Good luck with the codes ...

 

[STAR444]

Hi and welcome from SC! Good luck with your codes!! :smileup:

 

[DaveDees]

Possible Causes for DTC P0158:

(K243) O2 2/2 SIGNAL CIRCUIT SHORTED TO VOLTAGE(K904) O2 RETURN (DOWNSTREAM) CIRCUIT SHORTED TO VOLTAGE(K243) O2 2/2 SIGNAL CIRCUIT SHORTED TO THE (K399) O2 2/2 HEATER CONTROL CIRCUIT(K243) O2 2/2 SIGNAL CIRCUIT OPEN OR HIGH RESISTANCE(K904) O2 RETURN (DOWNSTREAM) CIRCUIT OPEN OR HIGH RESISTANCE2/2 OXYGEN SENSORPOWERTRAIN CONTROL MODULE (PCM)


Here is the info for the P0325:

Causes

A code P0325 most likely means one or more of the following has happened:

• The knock sensor is faulty and needs to be replaced
• There is a wiring short/fault in the knock sensor circuit

Possible Solutions

• Check the resistance of the knock sensor (compare it to factory specs)
• Check for broken/frayed wires leading to the sensor
• Replace the knock sensor

Hope this helps in fixing your codes....



BTW, welcome to the 'Z', from Virginia, glad to have you here with us.

 

[morgan82]

good luck hope you get it figured out soon

 

[Quiet]

I think Dave hit it right on the head.

To translate that first one, it's an O2 sensor DTC and usually means one of the sensors has failed, a connector has come loose or the wiring has a short in it.

 

[HPNO300]

welcome to the z from north tx :wavey:

 

[damageinc]

Welcome to the Z and good luck

 

[300 Addict]

Welcome to 300CForumZ, from Barrie, Ontario, Canada! Glad to have you join us here! Enjoy the site!

 

[TALLA]

hello and welcome to the forumZ

 

[HEMIPHIL]

:smiley_thumbs_up: Good to have you join us here on the Z!!! Hope the fix isn't too much of an inconvenience. Enjoy the forum, and the modding...